Audi A6

Note that you might need to turn the ignition off and back on twice for the customization to take effect.

Which start screen logos are supported is dependent on the module's firmware. Please note that setting a start screen logo which isn't supported may cause a "01543 - incorrectly coded" fault code - returning the original logo should fix the issue.

Note that this works only if your power mirror switch is set to control the passenger-side mirror.

After enabling all ADS settings here, you must also make changes via your MMI. See: blog.caristaapp.com

After enabling all ADS settings here, you must also make changes via your MMI. See: blog.caristaapp.com

Enabling this on a car without dynamic suspension may cause a "Headlight range control" error. Disable and reset codes if that happens.

Car should have active suspension.

Enabling this mode can be used for storage/transportation purposes. Note that when the mode is enabled your keyfob and alarm will be deactivated!

If the setting does not have any effect on the car please try to set "Auto start/stop system with engine running and driver's door opened (step 2 of 3)" to "Enabled (Version 2)". The setting is located under the Chassis & Engine category.

To enable this option, the climate control temperature with remote start must be set to a fixed value.

Note that you might need to turn the ignition off and back on twice for the customization to take effect.

Which start screen logos are supported is dependent on the module's firmware. Please note that setting a start screen logo which isn't supported may cause a "01543 - incorrectly coded" fault code - returning the original logo should fix the issue.

Note that this customization only applies when your headlight switch is OFF and it's daylight outside.

This setting is still experimental and it may fail to save. Feel free to try a few times, and if it still doesn't work, rest assured that we know about it and are working on it.

If activating this setting, make sure that Bluetooth availability is set to ON.

This setting enables the ability to use phone data for Audi MMI internet functionality instead of the Audi Connect SIM.

To use this retrofit setting, your infotainment unit must support CarPlay and have a retrofitted USB port compatible with CarPlay, along with a CarPlay license.

Sends a small voltage pulse to the specific bulb when the vehicle is off or first started to verify its presence. This may cause flickering with LED bulbs.

Controls whether the check control (CC) system displays an error when the specific bulb fails. If enabled, a warning appears on the dashboard.

Sends a small voltage pulse to the specific bulb when the vehicle is off or first started to verify its presence. This may cause flickering with LED bulbs.

Continuously monitors the specific bulb while the engine is running to detect failures. Disabling this can prevent warning messages for LED retrofits.

Sends a small voltage pulse to the specific bulb when the vehicle is off or first started to verify its presence. This may cause flickering with LED bulbs.

Sends a small voltage pulse to the specific bulb when the vehicle is off or first started to verify its presence. This may cause flickering with LED bulbs.

Continuously monitors the specific bulb while the engine is running to detect failures. Disabling this can prevent warning messages for LED retrofits.

Controls whether the check control (CC) system displays an error when the specific bulb fails. If enabled, a warning appears on the dashboard.

Continuously monitors the specific bulb while the engine is running to detect failures. Disabling this can prevent warning messages for LED retrofits.

Note that this works only if your power mirror switch is set to control the passenger-side mirror.

You must also enable the relevant comfort opening settings through a new MMI menu for this customization to work.

You must also enable 'Open/close windows/sunroof/roof via long-press on remote' and all other relevant settings for this to work.