Audi RS4

Note that this works only if your power mirror switch is set to control the passenger-side mirror.

After enabling all ADS settings here, you must also make changes via your MMI. See: blog.caristaapp.com

After enabling all ADS settings here, you must also make changes via your MMI. See: blog.caristaapp.com

Enabling this on a car without dynamic suspension may cause a "Headlight range control" error. Disable and reset codes if that happens.

Car should have active suspension.

Enabling this mode can be used for storage/transportation purposes. Note that when the mode is enabled your keyfob and alarm will be deactivated!

If the setting does not have any effect on the car please try to set "Auto start/stop system with engine running and driver's door opened (step 2 of 3)" to "Enabled (Version 2)". The setting is located under the Chassis & Engine category.

Note that the oil temperature may not display any value when the engine is cold.

Sends a small voltage pulse to the specific bulb when the vehicle is off or first started to verify its presence. This may cause flickering with LED bulbs.

Controls whether the check control (CC) system displays an error when the specific bulb fails. If enabled, a warning appears on the dashboard.

Sends a small voltage pulse to the specific bulb when the vehicle is off or first started to verify its presence. This may cause flickering with LED bulbs.

Continuously monitors the specific bulb while the engine is running to detect failures. Disabling this can prevent warning messages for LED retrofits.

Sends a small voltage pulse to the specific bulb when the vehicle is off or first started to verify its presence. This may cause flickering with LED bulbs.

Sends a small voltage pulse to the specific bulb when the vehicle is off or first started to verify its presence. This may cause flickering with LED bulbs.

Continuously monitors the specific bulb while the engine is running to detect failures. Disabling this can prevent warning messages for LED retrofits.

Controls whether the check control (CC) system displays an error when the specific bulb fails. If enabled, a warning appears on the dashboard.

Continuously monitors the specific bulb while the engine is running to detect failures. Disabling this can prevent warning messages for LED retrofits.

Note that this works only if your power mirror switch is set to control the passenger-side mirror.

Activating this feature may PERMANENTLY disable using your rear-view camera when in forward gear. If this happens, please email us at support@caristaapp.com.

This customization will only have effect if "Park distance visualization" is disabled.

You must also enable the relevant comfort opening settings through a new MMI menu for this customization to work.

You must also enable 'Open/close windows/sunroof/roof via long-press on remote' and all other relevant settings for this to work.